Because most Traeger grills make use of an Ortech digital temperature controller that’s precise within about 15 degrees of your setting, they may not be precise enough for the type of cooking you want to perform. If so, some pellet grill manufacturers, such as MAK, Yader, and Memphis, can give you temperature control within about 5 degrees of the setting. These types of grills use multiple temperature probes inside the cooking area to guarantee the temperature remains consistent. And some of these high-end brands can reach a higher cooking temperature (such as 600 or 700 degrees Fahrenheit) versus the Traeger family of grills (usually around 450 or 500 degrees). Additionally, MAK, Memphis, and Yader grills are made in the United States, while some parts of Traeger grills are made in China.
2. The grill does not come back to the set temperature after the lid is opened and closed to place the meat. I start it, close the lid, set the temp (startup procedure has changed to this according to Traeger service tech) and after 15 or 20 minutes it is not at the set temp yet...in fact it is declining. Well I need to cook on it and cannot wait forever so I open the lid quickly, throw the meat on, and close the lid quickly.
The original Traeger Grill was invented 30 years ago and was every bit as impressive then as it is now. Although it developed a cult following, the early Traeger never grew beyond a niche product. In the past two years, however, Traeger has stepped up its game, redesigning and upgrading its grills while doing everything it can to build a buzz around its amazing do-everything cookers.
I have used mine Traeger 15 times and it hasn't worked once. I will not hold the temp within 15 degrees as they state. I can set mine to 225 and will go between 180-370. It also consistently shutting itself off with the same error. I have spoken to cust service 12 times and they are worthless. I have had new controller sent and other various parts. I have been on the phone with them for hours. I always have to take my meat off and finish it on my Weber. They refuse to send me a new one. They still demand to go back through the same damn steps as the last 12 times to debug it. Never again. If you see my post on Craigslist, don't buy it, it's a lemon that Traeger will not support.